QGC: Calibration Buttons (Tare & Mag) not working/active
Posted: Tue Aug 15, 2017 4:45 pm
Hi all,
in my GCS the Buttons for doing a Tare/Mag calibration are not activated. Also, the transmitter stick commands for Tare/Mag Calib. do not work. Am I missing something, like putting the AutoQuad into flash mode? Or, has anybody else had this problem before?
I'm using FW v6.7.r224.b1400-rev1 and GCS versions 1.6.3.1 and 1.7.B3 for Windows.
Any advice is highly appreciated.
Best regards,
Stefan
in my GCS the Buttons for doing a Tare/Mag calibration are not activated. Also, the transmitter stick commands for Tare/Mag Calib. do not work. Am I missing something, like putting the AutoQuad into flash mode? Or, has anybody else had this problem before?
I'm using FW v6.7.r224.b1400-rev1 and GCS versions 1.6.3.1 and 1.7.B3 for Windows.
Any advice is highly appreciated.
Best regards,
Stefan