Page 1 of 1

QGC: Calibration Buttons (Tare & Mag) not working/active

PostPosted: Tue Aug 15, 2017 4:45 pm
by Snoopy
Hi all,

in my GCS the Buttons for doing a Tare/Mag calibration are not activated. Also, the transmitter stick commands for Tare/Mag Calib. do not work. Am I missing something, like putting the AutoQuad into flash mode? Or, has anybody else had this problem before?

I'm using FW v6.7.r224.b1400-rev1 and GCS versions 1.6.3.1 and 1.7.B3 for Windows.

Any advice is highly appreciated.

Best regards,
Stefan

Re: QGC: Calibration Buttons (Tare & Mag) not working/active

PostPosted: Sun Aug 20, 2017 12:35 pm
by aBUGSworstnightmare
Be sure to use the correct firmware! The one you mentioned is pretty old!

Use the Firmware download wizard or the ftp server to download latest version (FW 7.1.1925 and QGC 1.7b4).

aBUGSworstnightmare