Let's show it off!

Ground Stations and utilities for Windows, Linux, Android, & others

Re: Let's show it off!

Postby joebar.rc » Wed Nov 19, 2014 6:25 pm

Max wrote:Great demos guys! With enough power, I don't see why a full-sized couldn't fly with one motor of each pair being out. Depending on how the yaw balances out I suppose. Can it fly with both motors on one arm out, though? ;)

Steve, how are you driving the extra 4 motors? Parallel pairs from onboard motor drivers, or you have extra ESCs and all that?

Thanks,
-Max


Well with both motors on one arm out it is the same as a quad with one out. I could show you a number of video's in testruns for Srinath that all failed. Only one attempt with heavy code changes did stay in the air for a couple of seconds :).
We have been trying to get the 'quad' or in this config the x8 to get it yawing so fast the thrust loss would be compensated. Well, it could work on a small and cheating way with some balance shift, but practically.. no (well, I couldn't anyway).

@Steve, that is a great idea for getting props close together. A couple of years ago I did see an attempt from Hacker motors in the time that brushless was not that powerful to stack two motors with one motor having a hollow shaft, where the bottom motor shaft was running through.
With pancake motors it could be done. Only the bearings must be very tough because the stacked props could create quite a nasty shake.
joebar.rc
 
Posts: 1084
Joined: Fri Jun 22, 2012 8:59 am
Location: The netherlands

Re: Let's show it off!

Postby Kisssys » Wed Nov 19, 2014 8:38 pm

Menno,

About 10 years ago a friend took 2 AXI motors, one with a hollow shaft and made a really nice motor with the props contra rotating. We put it on a model simular the Convair XFY Pogo and were able to take off and land without any problems on the tail. The lack of torque made it pretty easy to do and didn't have to have huge surface deflections to get the job done. Spektrum has a new set of receivers with stabilization that I want to go back and try and fly it again but I unfortunately gave the motor away.

The large pancake motors that are made to have a slipring in the middle should be good candidates but would have to be rewound.

Max,

I didn't want to have to add another four motor drivers so I just put them in parallel. Not very efficient but it flew fine. It weighs close to 70 grams with battery so when all four props were off it was struggling but controllable. I pulled off each prop one at a time and it just got a little weaker each time. No control problems at all and it was just our normal Quatos.
Steve
Kisssys
Kisssys
 
Posts: 1340
Joined: Sat Jun 23, 2012 9:23 pm

Re: Let's show it off!

Postby LinuxDoc » Wed Jan 14, 2015 3:09 pm

Autoquad M4 - Ladybird V2
Last edited by kinderkram on Wed Jan 14, 2015 3:20 pm, edited 1 time in total.
Reason: Only the ID of the YT videos belong between the tags
LinuxDoc
 
Posts: 12
Joined: Mon Jan 12, 2015 11:18 am

Re: Let's show it off!

Postby kinderkram » Wed Jan 14, 2015 3:27 pm

Nice video, thx for posting!
Submitted to our M4 YT playlist.

btw: I´ve edited the YT link (see the note on the bottom of your post).

Norbert
kinderkram
 
Posts: 2911
Joined: Fri Jun 22, 2012 7:47 am

Re: Let's show it off!

Postby Teletubbie » Sat Feb 28, 2015 1:09 pm

I found a cheap Quad at the local drug store, 40Euro (with radio, Video cam with 4Gb micro mem card).
I put the M4 inn, with 600mah LiPo and Blue Tooth module.
total weight 95 Gram.
Using the M4_Ladybird_V2 PARAMS

Video:
http://youtu.be/0qDzPLcmQNE

//Frank
Attachments
IMG_20150228_122501.jpg
IMG_20150228_123521.jpg
Teletubbie
 
Posts: 162
Joined: Wed Jun 27, 2012 4:59 am
Location: Amsterdam, The Netherlands

Re: Let's show it off!

Postby kinderkram » Sat Feb 28, 2015 1:27 pm

Very nice find, flying good - a bit noisy, though.
What´s the flight time with 600mAh @ 95gr?

At a drug store? They obviously know how to please addicts with drugs of all kinds. :lol:
kinderkram
 
Posts: 2911
Joined: Fri Jun 22, 2012 7:47 am

Re: Let's show it off!

Postby Teletubbie » Sat Feb 28, 2015 1:39 pm

I know, not common to find it there.

It flies 6min with this setup.
Teletubbie
 
Posts: 162
Joined: Wed Jun 27, 2012 4:59 am
Location: Amsterdam, The Netherlands

Re: Let's show it off!

Postby dirk » Tue Mar 03, 2015 1:53 pm

Here is my newest M4 build. It is a FPV H-Quad.

Partlist
---------
Autoquad M4
Carbon Micro-H Frame from Micro Motor Warehouse.
Chaoli 0820-17 Motors
Ladybird Props
VA1100 Ultra Micro FPV Cam (it is a cam with buildin TX and antenna.)
1S 750mAh Lipos

dirk
 
Posts: 17
Joined: Thu Jun 05, 2014 3:04 pm

Re: Let's show it off!

Postby kinderkram » Tue Mar 03, 2015 2:26 pm

Nice one, Dirk!
Flies smooth and agile.

btw: how´s the VA1100 coming along - do you get a proper image on your goggles?
kinderkram
 
Posts: 2911
Joined: Fri Jun 22, 2012 7:47 am

Re: Let's show it off!

Postby LPR » Tue Mar 03, 2015 2:43 pm

I was quite surprised that I could get a GPS lock in my house so I had to see if it would be able to hover in Alt/Position Hold.



The quad has a M4 v1 board, 8.5 Hubsan motors and props and a custom 3D printed frame.

Larry
LPR
 
Posts: 1323
Joined: Tue Jun 26, 2012 1:29 pm
Location: MN, USA

PreviousNext

Return to AQ Software

Who is online

Users browsing this forum: No registered users and 5 guests

cron