QGC freezes during RC setup
Posted: Mon Nov 05, 2012 1:25 pm
While setting up my RC channels yesterday, I found out that QGC always freezes or even causes a bluescreen when the signal of a channel is too high or too low.
Environment:
OS: Win7 x64 (also testet on WinXP x86)
QGC: v1.0.1, AQ Widget v1.0.4
Receiver: Spektrum satellite, bound on DSM2, 10bit
One could advice not to exceed the maximum of a channel's signal (I think the GUI freezes if a signal exceeds 1000) but the problem is that each time I activate a new channel on my radio, it starts with 100% travel way.
On channels which are assigned to sticks, there was an easy workaround: After activating the channel, I set the travel way from 100% down to 40% before I did a first stick movement. Then I increased the range to set the endpoints. Unfortunately this is not possible with channels that are assigned to a switch because they will always be at one endpoint after activating.
Is it something you can fix? My raid controller had a lot of work last night to rebuilt the raid 3 times until I found the reason.
Environment:
OS: Win7 x64 (also testet on WinXP x86)
QGC: v1.0.1, AQ Widget v1.0.4
Receiver: Spektrum satellite, bound on DSM2, 10bit
One could advice not to exceed the maximum of a channel's signal (I think the GUI freezes if a signal exceeds 1000) but the problem is that each time I activate a new channel on my radio, it starts with 100% travel way.
On channels which are assigned to sticks, there was an easy workaround: After activating the channel, I set the travel way from 100% down to 40% before I did a first stick movement. Then I increased the range to set the endpoints. Unfortunately this is not possible with channels that are assigned to a switch because they will always be at one endpoint after activating.
Is it something you can fix? My raid controller had a lot of work last night to rebuilt the raid 3 times until I found the reason.