Cannot flash firmware (Using Parser: Intel HEX,Error device)
Posted: Thu Dec 01, 2016 11:33 pm
Good evening everyone!
Recently viewtopic.php?f=33&t=4900
I found how to solve an issue with reading/writing parameters, but now I found that I cannot update firmware..
Now I use a serial <-> USB connector with 4 pins on a serial side. I'm not sure how it's called, but QGG recognizes it as "Prolific USB-to-Serial Comm Port" (see Figure in the end).
I connect the serial the same way I did for reading/writing parameters (I connect RX, TX and GND) from a picture here: http://autoquad.org/wiki/wiki/autoquad- ... nnections/
I tried to connect with a +5V pin. Plus I tried to use Silicone Labs (CP210x) serial connector.
Also on this issue I found other pages:
viewtopic.php?f=26&t=3780
viewtopic.php?f=26&t=1636&p=6468&hilit=unusual+way#p6468
viewtopic.php?f=26&t=15&hilit=unusual+way&start=80
but they didn't help me to solve the issue..
So, currently I have a board with a DIMU soldered (it was already bouth like this and I think it is a comparatively new version of a board). When I connect to QGG it says that the version is 7.1 Experimental (it's written: "AutoQuad FW: v. 7.1.-EXPR r449 b1852 HW: v. 6r1")
I try to follow instructions for flashing on this page: http://autoquad.org/wiki/wiki/autoquad- ... 2-hardware
I didn't forget to remove jumper from J3 and place it to J4. When the AQ6 starts, it has only red LED blinking.
After trying to flash the firmware I see an error like this:
Thank you for your time and have a good day!
Recently viewtopic.php?f=33&t=4900
I found how to solve an issue with reading/writing parameters, but now I found that I cannot update firmware..
Now I use a serial <-> USB connector with 4 pins on a serial side. I'm not sure how it's called, but QGG recognizes it as "Prolific USB-to-Serial Comm Port" (see Figure in the end).
I connect the serial the same way I did for reading/writing parameters (I connect RX, TX and GND) from a picture here: http://autoquad.org/wiki/wiki/autoquad- ... nnections/
I tried to connect with a +5V pin. Plus I tried to use Silicone Labs (CP210x) serial connector.
Also on this issue I found other pages:
viewtopic.php?f=26&t=3780
viewtopic.php?f=26&t=1636&p=6468&hilit=unusual+way#p6468
viewtopic.php?f=26&t=15&hilit=unusual+way&start=80
but they didn't help me to solve the issue..
So, currently I have a board with a DIMU soldered (it was already bouth like this and I think it is a comparatively new version of a board). When I connect to QGG it says that the version is 7.1 Experimental (it's written: "AutoQuad FW: v. 7.1.-EXPR r449 b1852 HW: v. 6r1")
I try to follow instructions for flashing on this page: http://autoquad.org/wiki/wiki/autoquad- ... 2-hardware
I didn't forget to remove jumper from J3 and place it to J4. When the AQ6 starts, it has only red LED blinking.
After trying to flash the firmware I see an error like this:
Thank you for your time and have a good day!