Page 1 of 1

MSP telemetry output

PostPosted: Sat Feb 27, 2016 10:12 am
by brat002
Hi guys.
I am searching for good OSD firmware for AQ with rssi/current/horizon/voltage support. Best from functionality and usability point of view is MwOsd fork scarab-osd. But this osd firmware supports only MSP telemetry format.
Is any chance to get msp in AQ firmware?

Re: MSP telemetry output

PostPosted: Thu Mar 03, 2016 5:59 pm
by Mullet
Just curious what is wrong with the firmware that KISSYS made for AQ and minumOSD? Or is it missing something you are looking for?

Re: MSP telemetry output

PostPosted: Thu Mar 03, 2016 9:14 pm
by brat002
Cant find this firmware.

Re: MSP telemetry output

PostPosted: Thu Mar 03, 2016 9:45 pm
by Mullet
You should be able to find it in this thread...

viewtopic.php?f=40&t=4246

Re: MSP telemetry output

PostPosted: Thu Mar 03, 2016 10:16 pm
by brat002
Here are no rssi monitoring.

Re: MSP telemetry output

PostPosted: Thu Mar 03, 2016 10:42 pm
by Max
You can only get true RSSI directly from your Rx. Many now have solder points or headers to connect to an OSD. I don't know the specifics for the Minum or what Rx you have.

AQ does send the "radio quality" as a mavlink message, so I can't imagine it would be hard to get that displayed on the Minum instead of true RSSI. But again I'm not familiar with the code.

-Max

Re: MSP telemetry output

PostPosted: Fri Mar 04, 2016 10:45 am
by brat002
I use microminim osd that has pads for voltage/rssi/current monitoring. Here are just one problem - only scarab-osd/mwosd can read values from these pads.