HEX File

[s_sergiu]

Hi,

Where exactly is the hex file for autoquad?

Thanks,
Sergiu

[kinderkram]

Here: http://autoquad.org/software-downloads/?category=3

These are zipped and pre-compiled versions of the release and the experimental firmware.

[s_sergiu]

Found.
Thank you,
Sergiu

[afernan]

Just bought an AQ, wayting to receive it. What tool is used to compile the code and generate a especific HEX file?
Thanks
Angel

[joebar.rc]

[afernan]

@Joebar:
thanx for your info.
Done at first shot the installation of compiler and created my first HEX. Wiki page is clean & clear. Congratullations.
Angel

[afernan]

I´ve downloaded the HEX file for V6.5 Mavlink version from " AutoQuad firmware « Downloads" and I found an "elf" file instead HEX. I´ve googled the difference ind it looks it must be converted to HEX before uploading to AQ.
I´m newbie in AQ, could you explain a bit about this?
Thanks

Angel

[kinderkram]

[afernan]

@kinderkram
Thanks, now is OK an .HEX file
I´ve tryied to flash it by my first time, and I´ve found following message:

===========================================
stm32flash - http://stm32flash.googlecode.com/
read_byte: No error
SERIAL_ERR_NODATA

Assertion failed: 0, file stm32.c, line 94

This application has requested the Runtime to terminate it in an unusual way.
Please contact the application's support team for more information.

Using Parser : Intel HEX
Using Parser : Intel HEX
Serial Config: 57600 8E1
=======================================
Any idea?. I can see 57600 8E1, should it be 112500? where to change?.
Thanks
Angel

[Wingspinner]

In my experience this is due to a corrupt .hex file.

Ron