Co Axial Hexa H with AutoQuad6
Posted: Fri Jul 10, 2015 5:21 am
Hi
I am in the process of building a "Co Axial Hexa-H multicpopter" (12 motors - co axial)
In the motor mixing setup, it was mentioned that I can customize the motors based on my configuration using the custom option.
If I do so are there any other changes that I need to do in the ground control software.
Thanks
I am in the process of building a "Co Axial Hexa-H multicpopter" (12 motors - co axial)
In the motor mixing setup, it was mentioned that I can customize the motors based on my configuration using the custom option.
If I do so are there any other changes that I need to do in the ground control software.
Thanks