Page 1 of 1

Co Axial Hexa H with AutoQuad6

PostPosted: Fri Jul 10, 2015 5:21 am
by funfrancis
Hi

I am in the process of building a "Co Axial Hexa-H multicpopter" (12 motors - co axial)

In the motor mixing setup, it was mentioned that I can customize the motors based on my configuration using the custom option.

If I do so are there any other changes that I need to do in the ground control software.

Thanks

Re: Co Axial Hexa H with AutoQuad6

PostPosted: Fri Jul 10, 2015 8:03 am
by aBUGSworstnightmare
Hi,
get in touch with Tilman asking him for his Motor mix. Should get you started faster when doing your customized mixing table.
viewtopic.php?f=25&t=4420
Joerg