Co Axial Hexa H with AutoQuad6

News, Setup, Compiling, Flashing, Development

Co Axial Hexa H with AutoQuad6

Postby funfrancis » Fri Jul 10, 2015 5:21 am


I am in the process of building a "Co Axial Hexa-H multicpopter" (12 motors - co axial)

In the motor mixing setup, it was mentioned that I can customize the motors based on my configuration using the custom option.

If I do so are there any other changes that I need to do in the ground control software.

Posts: 1
Joined: Fri Jul 10, 2015 5:06 am

Re: Co Axial Hexa H with AutoQuad6

Postby aBUGSworstnightmare » Fri Jul 10, 2015 8:03 am

get in touch with Tilman asking him for his Motor mix. Should get you started faster when doing your customized mixing table.
Posts: 1460
Joined: Fri Jun 22, 2012 5:24 pm

Return to AQ Firmware

Who is online

Users browsing this forum: No registered users and 5 guests