battery charge level and motor can't rotate normally

News, Setup, Compiling, Flashing, Development

battery charge level and motor can't rotate normally

Postby EX_TRUE » Wed Jun 03, 2015 7:49 am

1.
The battery voltage is 14.6, but remain battery charge level is 100%.
my low battery setting : stage 1 warning 3.3; stage2 warning 3.1.

2.
It is strange that it did not beep as usual(because it disarmed)after I power on the AQ and ESC, and I armed the AQ,but the motor didnot rotate.
I must try to power on the AQ and ESC again until it beep, then the motor could rotate normally after armed.

My airframe X450
AQ hw6.1 dimu1.1 firm7.0
battery 4s
Motor: sunnysky 3508 580KV
ESC: Hobbywing Platinum-30A
EX_TRUE
 
Posts: 51
Joined: Mon Nov 10, 2014 8:57 am

Re: battery charge level and motor can't rotate normally

Postby aBUGSworstnightmare » Wed Jun 03, 2015 8:17 am

I'm sorry, but I'm not sure if I got your problem right :oops:

You're describing that you've connected the battery but the craft did not arm? Have you checked the LEDs on the AQ6 by chance? Sounds like the board did not boot for some reason. Maybe you should get an anti-spark plug for your LiPo.
Joerg
aBUGSworstnightmare
 
Posts: 1460
Joined: Fri Jun 22, 2012 5:24 pm

Re: battery charge level and motor can't rotate normally

Postby EX_TRUE » Wed Jun 03, 2015 8:47 am

The board did boot, the QGC HUD is OK
and the ready led is blink.
EX_TRUE
 
Posts: 51
Joined: Mon Nov 10, 2014 8:57 am

Re: battery charge level and motor can't rotate normally

Postby jet » Fri Jul 03, 2015 2:31 pm

Hi, EX_TRUE.
I did not know whether or not you solved this problem.
I ever met similar problem.
I checked the power cable from battery to AQ6.
In the meantime, I flashed the firmware again.
Then, the problem was solved.
jet
 
Posts: 69
Joined: Wed Mar 05, 2014 2:23 am

Re: battery charge level and motor can't rotate normally

Postby EX_TRUE » Sat Jul 04, 2015 7:16 am

Hi jet,

I haven't solve these problem.

If I first power AQ6 then power ESC, it is OK..



Thanks :D
EX_TRUE
 
Posts: 51
Joined: Mon Nov 10, 2014 8:57 am

Re: battery charge level and motor can't rotate normally

Postby jet » Sat Jul 04, 2015 9:35 am

Hi, EX_TRUE.
For your second problem, you could try a method as well as below.
Keeping the UAV 10-30CM away from the ground when you power up your UAV.
Wish you could find out the problem soon.
jet
 
Posts: 69
Joined: Wed Mar 05, 2014 2:23 am


Return to AQ Firmware

Who is online

Users browsing this forum: No registered users and 10 guests

cron