I'm currently playing with the frsky X4R receiver through Sbus. As the 3 pwm port cannot be programmed to a higher channel I'm looking at using the passthrough option on the AQ board for switching led's
I'm using fw 7.0 r416.
In the GCS I programmed ch9 as the passthrough input and as passthrough output I chose PWM port 14.
Starting everything up the rc switch is off. Switching the leds on works but I can't switch them of again. In the rc channel monitor I can clearly see that the channel works.
Also when using the X8R and its pwm port it works great.
Any solution to this?