Sim3 crashes on loop 3

News, Setup, Compiling, Flashing, Development

Sim3 crashes on loop 3

Postby kboysz » Tue Jul 24, 2012 7:56 am

I'm trying to start Step4b: sim3 --acc calculations and is starts and loops twice and when its on the third loop sim3 aborts and crashes. I also tried to do the calculations in Linux but it doesn't work, I also rebooted the computer and restarted the calculations but always aborts on the third loop. :?:
kboysz
 
Posts: 3
Joined: Tue Jul 24, 2012 7:29 am

Re: Sim3 crashes on loop 3

Postby sandmen » Tue Jul 24, 2012 11:20 am

Please post a screenshoot.
sandmen
 
Posts: 997
Joined: Fri Jun 22, 2012 7:25 am

Re: Sim3 crashes on loop 3

Postby chschmid » Tue Jul 24, 2012 3:31 pm

I had the same behavior. I think in my case, the calypso was not done properly. When it started to rain, I tried to finish quickly. I did the dynamic again and: voila, good results.
chschmid
 
Posts: 1800
Joined: Wed Jul 11, 2012 7:41 pm
Location: Herrliberg, Switzerland

Re: Sim3 crashes on loop 3

Postby CaptainPlanetHD » Sun Aug 19, 2012 6:41 am

Thank you! I will try that, too cause mine cashes after loop 46!
CaptainPlanetHD
 
Posts: 34
Joined: Mon Aug 06, 2012 8:56 am


Return to AQ Firmware

Who is online

Users browsing this forum: No registered users and 12 guests

cron