Page 2 of 2
Re: Another problem compiling with CrossWorks 3.3
Posted:
Wed Dec 10, 2014 6:58 am
by HeliHenkie
Hi Max, Steve,
Thanks for your reply.
@Steve: If everything goes according to plan I will receive a Quatos license for my brand new AQ board. So the availability of Quatos should be no problem. If you or Menno need a beta tester to speed up public release of the adapted firmware I'm your man! My quadcopter is an exact copy of the reference quad 400 Angel presented in the AQ media showcase.
Best regards,
Jan Willem
The Netherlands
Re: Another problem compiling with CrossWorks 3.3
Posted:
Sun Dec 14, 2014 9:31 am
by HeliHenkie
Hi all,
With CrossWorks 3.3 compiling works but linking fails.
See attached image for program output.
Did anyone encounter the same problem and have a solution?
Best regards,
Jan Willem
The Netherlands
Re: Another problem compiling with CrossWorks 3.3
Posted:
Sun Dec 14, 2014 10:46 am
by DUKE40
Hi Jan,
as far as I know, only team members can compile a Quatos based firmware, as the required libraries are only available to them and will never be released outside the AutoQuad Team.
This might be the reason for your compiling / linking failing.
Re: Another problem compiling with CrossWorks 3.3
Posted:
Sun Dec 14, 2014 11:47 am
by Max
Jan, try this:
viewtopic.php?f=31&t=3825&start=10#p26961The problem is very likely the versions of those 2 files mentioned. Replace them from the STM32...Lib_V1.3.0 distribution as mentioned in that post (don't use 1.4.0). If you don't have 1.3.0, I put a copy up on our site.
-Max
Re: Another problem compiling with CrossWorks 3.3
Posted:
Sun Dec 14, 2014 6:57 pm
by HeliHenkie
@Max: Almost there compiling my own firmware with the "Makefile method" on my Windows 7 PC.
Only one problem left while linking.
I seem to be missing the following file: c:/cw/lib/libc_targetio_impl_v7em_fpv4_sp_d16_hard_t_le_eabi.a
This file was not installed with CrossWorks 3.3 .
Does this problem seem familiar to you?
Could you post the missing file?
Best regards,
Jan Willem
The Netherlands
Re: Another problem compiling with CrossWorks 3.3
Posted:
Sun Dec 14, 2014 7:59 pm
by aBUGSworstnightmare
Re: Another problem compiling with CrossWorks 3.3
Posted:
Sun Dec 14, 2014 8:05 pm
by aBUGSworstnightmare
Re: Another problem compiling with CrossWorks 3.3
Posted:
Mon Jan 11, 2016 3:30 am
by tevada2010
I am too. Use CrossWorks 3.3 problem can't found stm32f4xx.h: No such file or directory. Help.