by DUKE40 » Sat Aug 09, 2014 9:32 am
I am using r403 from Menno for Rev1 Board, I did not check in QGC up to now, it was on the HoTT Telemetry.
I will check with QGC, but I do not expect anything different. Checked QGC shows 7.9V my lipo-checker simultaneously attached shows 11.47V so quite a discrepancy.
QGC is v1.5 Alpha 6 self compiled, as I work on Linux.
I am using DIMU.
And as already mentioned, everything was fine a few flights, and when I wanted to fly again last week suddenly the HoTT telemetry showed a much lower voltage than the current voltage of my accus.
Best regards,