Hello,
I have been working with the AutoQuad 6 controller this summer and wanted to get my feet wet writing some custom code to compile and upload. Before I tried my own code, I downloaded the vanilla hex file (aqv6.7r224.b1400-rev1) to go through the steps of flashing the firmware. With the new firmware successfully written I re-uploaded the on-board parameters that had worked previously and found that the ESC32's would not arm.
After some initial testing, the problem looked similar to viewtopic.php?f=26&t=1792 but my ESC32s were pretested and working moments before the firmware update. It seems that whatever is causing the problem is not in the ESC32 config settings but in the onboard parameters.
If someone could point me towards what parameters I need to change, it would be greatly appreciated.
Thanks,
Drew