WARNING! NEW radio type sort order! r406+

[kinderkram]

Be warned: The latest fw versions from r406 upwards use a different approach arranging the radio types. QGC 1.3 and lower versions don´t reflect that matter.

Upgrading to latest version of QGC is highly recommended!

You will need to manually change the radio types in the parameter list, transmit and save them for now.
Restart/reboot/repower the FC, refresh the parameters list to make sure they were stored correctly!


The above example shows the config of the internal Deltang receiver on the M4

To change externally attached radios use these values in the parameter list for "radio setup", store them and restart:

radio type is -1
radio setup is like 48 (sbus) und 64 (ppm)

internal deltang only = 7
ext. spektrum 11bit = 16
ext. spektrum 10bit = 32
ext. s.bus = 48
ext. ppm = 64

[afernan]

[bluuu]

internal radio type is deltang (7 in dec)

[Kisssys]

[Sascha]

Hi,
so for the M4 use with Graupner GR12-SH+ HoTT V1.01 (update to SumD)i put 80 into Radio Type? Any other changes to do?

Greetings

Sascha / Makerfair 2014

[kinderkram]

Hi Sascha,

the order changed in fw r406: https://code.google.com/p/autoquad/source/list
If you use the r402 that originally came with Jussi´s M4s, the old order applies.

[JussiH]

The R402 on the bare boards is a PID version that was flashed for testing purposes. You should get the newest quatos version off the trunk and send your serial number to srinath for him to generate you a license key.

[srinath]

If i want to run R417 on a rev-4 M4 board, are these the right radio settings ?

radio_type -1
radio_setup 16 (11 bit spektrum external satellite)

[Kisssys]

Yes, that should work for a 11 bit radio.

[codeforge]

Hi,
the deltang led on M4 is not blinking, even if i try to bind with a spektrum dx7s. When i bind on the radio i see "binding" and then "transmitting" but nothing appen on deltang led in M4 board. And in QGC cannot move stick/channels... Any suggestion?

thanks