Hi,
The session.txt file has a last change date of 03.07.2014 which is right, even if the time is not 100% right (18:34 instaed of 22:40).
Further the value in the session.txt file is increasing every time I power the AQ, but no new file is created on the SD-card.
What is going on?
The AQ board is new, has only 3 hover flights yesterday, and I still have no other files on the SD-card.
Removed all files form SD-card (only session.txt).
Powering up the AQ, making a few tests of the Gimbal and checking the HUD, disconnecting the power, I have on the SD-Card only the session.txt file with a valuer of 1 and no other files at all.
Is something wrong my AQ Board?
I use the following Firmware:
r397 with native HoTT support from the AutoQuad download section.
Based on this I have currently no possibility to check if my motor / prop combination is OK, or there is some clipping of the motors.
This makes me quite uncomfortable to get it in the air.