Hello,
i found a strange behavior in the v7.0 r406:
First: I use PPM. Why the "enum radioTypes" and the default Radiocontrol is changed from -1 to 0? In the QGC I i have to select SUMD (Graupner) for PPM.
The main Problem is, that the Function behind the Button Write(ROM) deletes the flash. After a Reset the defaults are loaded.
If i use the rc sticks to save the Parameter it works fine. But if i klick on the Button in the QGC i get the following Messages:
FAILURE: Temporarily rejected CMD: 245
config: Parameters saved to flash memory.
In my Debugwindow (Adr 0x080E0000) the flash is completely set to 0xFF.
If i stop the programm with a Breakpoint in the Function "flashAddress()" at the line "FLASH_ClearFlag(...);" and continue the programm, it works fine too.
Same Problem is behind the Button "Save Settings to AQ". (I think its the same Function)
EDIT: QGC is v1.4.0
Any ideas?
regards
Florian