Failsafe with Jeti RX

News, Setup, Compiling, Flashing, Development

Failsafe with Jeti RX

Postby boriss » Sat Jun 07, 2014 11:33 am

Hi Guys,

any of you flying with a jeti setup and have failsafe working ?

I have my copter setup with a RSAT and I cant get AQ to recognize the signal loss between the RX and the Radio. The RSAT has to send out some sort of Failsafe signal since my DJI setups recognize the signal loos and enter failsafe.

Int QGC signal always stays at 100% also if signal loss is forced. On the level of each individual channel JETI lets you set options on the RX to either hold or give each channel a certain value in the case of loss.

Any Ideas ?

Thanks

Boris
boriss
 
Posts: 204
Joined: Wed Aug 08, 2012 7:26 pm

Re: Failsafe with Jeti RX

Postby boriss » Sat Jun 07, 2014 2:01 pm

Ah found the mistake on my side ! There is a general on an off failsafe setting for jeti RXs. Failsafe has to be switch off as a global setting, than AQ gets the info that the signal is lost and performs !

Thanks

Boris
boriss
 
Posts: 204
Joined: Wed Aug 08, 2012 7:26 pm


Return to AQ Firmware

Who is online

Users browsing this forum: No registered users and 17 guests

cron