Ok surely there is something i am missing
I have been through the calibration sequence
Everything is perfect according to the wiki
My quad is level in the hud
I checked orientation with the hud and all movements match what i am doing
The motors are connected as per motor mix table and escs are calibrated
I am using hitec radio with a frisky ppm rx
When. I try to take off it is not lifting level and if i throttle up it will flip
Set up is just a simple x quad f450 frame, f30 escs with Simon K fw and sunnysky 980 over with apc 8x4.7 props
I am pulling my hair out here I had read the wiki so many times while waiting for the qgc to run the Sims I thought I would have had it covered but I just can't seam to get it to lift off
hopefully somebody here had some idea what may be wrong
this isn't my first build but is my first aq