Newer firmware (not RC1) require new parameter file?

News, Setup, Compiling, Flashing, Development

Newer firmware (not RC1) require new parameter file?

Postby Jdmagoo » Fri Feb 28, 2014 9:21 am

I haven't worked out which firmware version it occurs but when i change to something other than R224 the HUD is not level.

Also, when i take off the craft leans to one side and requires roll correction from the Tx to stabilise. When i revert back to R224 the HUD is level again and the craft launches without issue.

So, based on this do i need to re run my cals (static and dynamic) with the newer firmware versions?

Thanks in advance

James
Jdmagoo
 
Posts: 485
Joined: Sun Feb 17, 2013 8:35 am

Return to AQ Firmware

Who is online

Users browsing this forum: No registered users and 15 guests