Page 1 of 1
RTH doesn't work
Posted:
Wed Feb 19, 2014 12:07 pmby michal_e
hi
I'm just starting with AQ.
Four days ago Return to Home in my quad AQ was working OK.
After some changes ( especially PID's) it doesn't work properly - after switch RTH copter only changing YAW orientation but not going to HOME point.
what could I set wrong ?
P.S.
SET HOME and RTH is switching in 3Dfix. (blue light)
Re: RTH doesn't work
Posted:
Wed Feb 19, 2014 12:23 pmby bluuu
post your current settings of NAV pids
Re: RTH doesn't work
Posted:
Wed Feb 19, 2014 6:03 pmby michal_e
my PIDs:
Navigation Speed Rate
P: 10.5
I: 0.0075
PM: 20
IM: 20
OM: 30
NAv Distance Rate
P: 0.5
I: 0
PM: 999
IM: 0
OM: 999
Nav Alt Speed
P: 230
I: 1.5
PM: 150
IM: 700
OM: 700
Nav Alt Position
P: 0.2
i: 0
PM: 2.5
IM: 0
OM: 2.5
furthermore, as I good remember, betwen (RTH work) and (RTH doesn't work) I've set MAGNETIC DECLINATION TO 5.22 because i didn't it before.
Re: RTH doesn't work
Posted:
Thu Feb 20, 2014 7:11 pmby michal_e
OK, "problem" is solved - there was too much trim on PITCH.
I didn't know it has meaning.
Re: RTH doesn't work
Posted:
Thu Feb 20, 2014 7:22 pmby JussiH
RTH will not execute until the copter considers itself in a hold state. If there is too much trim on the cyclic input you will be outside the deadband and the copter will enter DVH mode because it thinks you are trying to move its position with the RC control.
Solution is to increase the pitch/roll deadband under radio and controls tab.