I have updated my AutoQuad with an own compiled Firmware 6.8-BETA r229 because I had to activate te transmission of the GPS coordinates for the Mav2HoTT telemetry, but for some reason the motors wont spin.
The AQ is armed, but moving the throotle stick I see in the log attached no motor output at all.
Anybody an idea what might be causing this?
I noticed also that despite having a 3S Lipo connected to the AQ it always retun through 'Mavlink a voltage of 7.6V meaning only a 2S is detected. Could this be the missing link? Does this mean something is wrong on my AQ?
Any help would be appreciated.
Attached my Log
- 051-AQL.zip
- Log
- (4.57 MiB) Downloaded 717 times
and the Mavlink output
- 051-MSG.LOG
- Mavlink messages
- (812 Bytes) Downloaded 732 times