I've just flashed the pre-built R211 firmware from the download page, but after flashing, then loading my parameter file, and writing ROM it seems that my parameters won't hold after I power cycle the board.
I'm using QGC 1.3 B3, and I'm using the 'Pilot -> Onboard Parameters' section. I load my parameter file, which appears successful, and then I write rom which gives me the confirmation '(MAV 026) SUCCESS: Executed CMD: 245', and my parameters look to all be there correctly. I can then click 'read ROM' and refresh, and my parameters are there, but as soon as I power cycle the board, they are back to defaults.
What am I doing wrong?