Page 7 of 8
Re: Firmware builds at Google code site
Posted:
Sun Sep 01, 2013 8:04 amby joebar.rc
Heading free is based on DVH, so you cannot engage heading free from a manual switch position.
Menno
Re: Firmware builds at Google code site
Posted:
Sun Sep 01, 2013 8:27 amby chschmid
Re: Firmware builds at Google code site
Posted:
Sun Sep 01, 2013 11:06 amby joebar.rc
I believe so, although I'm not sure about the set heading for heading free.
I have my own routine for that (using the set pos switch that sets the heading when in heading free mode, in any other mode re-sets the home pos), so I have to check but I think that's it indeed.
Menno
Re: Firmware builds at Google code site
Posted:
Mon Sep 30, 2013 3:23 amby monkey1
Thanks for this Max, good job. Would you decide to put ESC32 compiled firmware also?
Re: Firmware builds at Google code site
Posted:
Tue Jan 28, 2014 10:13 pmby epyonxero
Is there anywhere to see a changelog for the experimental firmware versions?
Re: Firmware builds at Google code site
Posted:
Tue Jan 28, 2014 11:18 pmby kinderkram
Re: Firmware builds at Google code site
Posted:
Sun Feb 23, 2014 1:27 amby Jdmagoo
Just wondering when the next nightlies will be uploaded?
Thanks again for your time and effort
Re: Firmware builds at Google code site
Posted:
Sat Mar 01, 2014 9:33 pmby Max
Unfortunately Google stopped accepting new uploads back in January, and I haven't had time to figure out where else to put them. The AQ site downloads take too long to set up. I'm thinking of maybe just dumping them in FTP folder(s) for now...
-Max
Re: Firmware builds at Google code site
Posted:
Sun Mar 02, 2014 12:05 amby kinderkram
I`ve created a new section "Experimental Firmware":
http://autoquad.org/software-downloadsIf you find no other place for these 500k crumbs - just dump them in /wp-content/exp-fw/
Re: Firmware builds at Google code site
Posted:
Sun Mar 02, 2014 1:17 amby teramax