Page 1 of 1

AQ6 + DIMU, ESC32v2, T-Motor MN3110, Stella XAircraft Gimbal

PostPosted: Mon Jan 02, 2017 6:15 pm
by b4lrog
Dear AQ community,

I would like to offer my 450mm AQ6 quadcopter in parts. It turns out that it was a bit too large to carry with a bicycle, which is why I moved onto smaller foldable quadcopters.

The conditions of the components are all nearly brand new (see also attached photos). I used the copter a total of three times for a total flight time below 2h.


The components are the following:

1x AutoQuad 6 with Digital IMU v1.1, GPS antenna, GPS ground plate shield and USB-UART
4x Autoquad ESC32 v2 (connected via CAN bus)
Price together: 230 EUR

4x T-Motor MN3110-17 700KV
2x Tiger 1137 Carbon Fiber Propeller CW&CCW V2
2x Tiger 1137 Carbon Fiber Propeller CW&CCW V2 (brand new, still sealed)
Price together: 160 EUR

1x Stella von XAircraft Brushless Gimbal für GoPro
Price: 150 EUR

Packages:
AQ6+ESC32+Motors+Props, combined price: 360 EUR
AQ6+ESC32+Motors+Props+Gimbal, combined price: 480 EUR

(+shipping from Germany)

In case you are interested I will add the depicted Warthox frame with custom carbon arms (including the LEDs) and a high and low carbon landing gear for free.

cheers
Carsten

Re: AQ6 + DIMU, ESC32v2, T-Motor MN3110, Stella XAircraft Gi

PostPosted: Sun Jan 15, 2017 8:59 pm
by b4lrog
Due to the overwhelming interest ;)
all rices are reduced by >10%


AQ6+ESC32: 200 EUR
Motors+Props: 140 EUR
Gimbal: 130 EUR
AQ6+ESC32+Motors+Props, combined price: 310
AQ6+ESC32+Motors+Props+Gimbal, combined price: 420 EUR