now that Menno released the Arduino sketch and with the boards working flawlessly I'm selling two of my Mav2Telem boards. The CAN bus is populated for a QUAD configuration, CAN bus termination resistor (2. one) is in place.:
Here are the details (for those who didn't come across so far):
- 5V/3A DC/DC, Vin = 42V max.
- 12V/1A DC/DC, Vin = 42V max.
- 3.3V/0.5A DC/DC
- up to 8 powered CAN slots, only 4 on TOP populated (+ 1 CAN input)
- 4 IntelliLED WS2812B ports
- MavLink input (from AQ6)
- Spektrum X-Bus interface for connecting to TM1000 and/or other sensors
- HOTT telemetry output
- Current sensor input (for use with breakout board designed by joebar; refer to http://oshpark.com/shared_projects/NL4NSScO for details)
- Arduino ProMicro socket for ‚Mav2Telem‘ (AVR ISP interface provided in case the boot loader needs to be swapped/updated)
Here am some sample telemetry screens from the AQ6 + Mav2Telem board on a Spektrum DX10T:
Find the sources here:
Schematic/BOM and docu is here:
Some more information on the board and it's possibilities can be found in the CamCruiser build log (this is the craft im using the board with/tested it) and in various other threads here in the forum.
Example of usage:
- The board I'm flying in the CamCruiser: wiring the craft is quite easy. Only two wires from the AQ6 needs to be connected (UART + CAN)
I will include some 4-pin ZH connectors so you can get your wiring done
(use to get pre-crimped wires cheap)
Let me know your location and I send you a quote on the shipping cost!
Looking for matching LED boards: see here