yaw overshoot on my Octo
Posted: Sat Feb 25, 2017 6:42 pm
Hi,
1/ Just built my new octo without quatos. Just a problem with the yaw After a yaw 360° it dont stop but oscillate + - around the stop point.
I tested several values of Yaw Ang, but nothing is good.
2/ Octo with quatos: I can arm the motors but trying to run the motors with throttle, it crash the AQ7 ???? I must power down and power up to try again but crash.
Firm 7.1 1852 hw6.1 quatos.
An idea ??
Thanks
Alain
1/ Just built my new octo without quatos. Just a problem with the yaw After a yaw 360° it dont stop but oscillate + - around the stop point.
I tested several values of Yaw Ang, but nothing is good.
2/ Octo with quatos: I can arm the motors but trying to run the motors with throttle, it crash the AQ7 ???? I must power down and power up to try again but crash.
Firm 7.1 1852 hw6.1 quatos.
An idea ??
Thanks
Alain