Re: Electric problem using a camera trigger cable
Posted: Fri Oct 30, 2015 5:43 pmAutoQuad Forum
AutoQuad :: Autonomous Multi Rotor Vehicle Controller
http://forum.autoquad.org/
Electric problem using a camera trigger cable
Page 2 of 2
Posted: Fri Oct 30, 2015 5:43 pmRe: Electric problem using a camera trigger cable
Posted: Mon Nov 02, 2015 1:12 pmWell, obviously my AQ board has an electrical problem but maybe the solution would be replacing a component. Can someone give me any idea of what component is damaged?
Re: Electric problem using a camera trigger cable
Posted: Sun Nov 08, 2015 7:43 pmThe recom who's near of the SD Card has a 0 output voltage. I will change it.
Re: Electric problem using a camera trigger cable
Posted: Wed Dec 09, 2015 9:37 amI have changed the recom and now the voltage outpot it's ok, but the problem still there.
Re: Electric problem using a camera trigger cable
Posted: Mon Dec 14, 2015 11:18 amRe: Electric problem using a camera trigger cable
Posted: Sun Jan 03, 2016 12:26 pmI decided to buy a new AQ board. In summary, when I made the connection to use the trigger cable, an electrical short circuit occurred for unknown reasons. As a result the Spektrum receiver stopped working and AQ board indicated a higher voltage level. After change one of the recoms, the problems persisted.
In few days, I'm going to need help to configure my new gimbal and the trigger cable.
Thanks.
In few days, I'm going to need help to configure my new gimbal and the trigger cable.
Thanks.
Re: Electric problem using a camera trigger cable
Posted: Sun Jan 03, 2016 6:07 pmManuel
One thing about the AQ boards that might be your problem is that you need to not have the boards powered when you connect to any port.
Larry
One thing about the AQ boards that might be your problem is that you need to not have the boards powered when you connect to any port.
Larry
Re: Electric problem using a camera trigger cable
Posted: Tue Jan 12, 2016 3:07 pmThanks Larry. Maybe that was the problem.