Electric problem using a camera trigger cable

[aBUGSworstnightmare]

I use an 4S battery. LiPo/Lion cells are 3.7V nominal (4.2V max and 3.2V min), so a 4S pack should go up to 4*4.2V = 16.8V < 18.19V.

I have the last version on AQ6 (version r1). Firmware: aqv7.1.1852-hwv6.1-dimu1.1.hex. I'm going to put the spektrum satellite in the arm with short cable protected by foam . Thanks.

-Manuel

Not IN the arm! If inside the arm it will not receive anything since CFK acts like a shield.

[Mlozano]

Well, obviously my AQ board has an electrical problem but maybe the solution would be replacing a component. Can someone give me any idea of what component is damaged?

[Mlozano]

The recom who's near of the SD Card has a 0 output voltage. I will change it.

[Mlozano]

I have changed the recom and now the voltage outpot it's ok, but the problem still there.

[aBUGSworstnightmare]

I have changed the recom and now the voltage outpot it's ok, but the problem still there.

Which problem is still there? AQ6 not booting/running or problem with the camera trigger?

[Mlozano]

I decided to buy a new AQ board. In summary, when I made the connection to use the trigger cable, an electrical short circuit occurred for unknown reasons. As a result the Spektrum receiver stopped working and AQ board indicated a higher voltage level. After change one of the recoms, the problems persisted.

In few days, I'm going to need help to configure my new gimbal and the trigger cable.

Thanks.

[LPR]

Manuel

One thing about the AQ boards that might be your problem is that you need to not have the boards powered when you connect to any port.

Larry

[Mlozano]

Thanks Larry. Maybe that was the problem.