AutoQuad Forum

Hey Guys,

I think my AQ6 r1 Board ripped. I was testing the board with some servos (with uBEC) and at some point the AQ Board was dead. No Light is on and (it seems to be that) the R13 is getting very hot. The recoms working well and there was no reversing voltage polarity.
Has anyone an idea what was happened and what should I do now? Thank you in advance.

Kind regards
TheBone

Sorry for the delay...
Could you please describe what exactly you have done?
Maybe Jussi or someone else can chime in. You could also send him a pm and ask for an inspection and/or repair.

Like Peter aka sandmen mentioned in another thread the MCU might be toast...

I used the following configuration.

The servos are plugged on a power distribution board which is powered by a uBEC. The signal comes from the AQ Board.

Does anybody see the fault or know what's going wrong?

I found that it's not hard to destroy the MCU by connecting servo wires with the AQ powered. I also found it's not hard to destroy the MCU if you connect serial wires while the AQ is powered.

The good news is I found it's not too hard to change the MCU.

Larry

Thank you for your answer.

How can I check the MCU and when the MCU is broken, where can I buy a new one? Do I have to do some SMB stuff or can anyone do that for me?

Thank you in advance.

I can replace the MCU for you, but it costs 45 EUR + return shipment.

Yes, I got it. Will write a reply now.

Hey Jussi,

I know, you're very busy, but could you please give me a last answer?
Tank you in advance.

Greetings
Chris

Hi TheBone

I have the same problem with you. I have replaced the stm32 by myself to fix it. Here is my fix post viewtopic.php?f=33&t=4390

If you live in Asia, i can help you. But Jussi will say cant help you further more if you fixed by myself.