I have to confess that I have found the AutoQuad 6 configuration and set-up environment is just too complex for me. I read through the Wiki and the various steps seemed ‘do-able’ to me, and so I acted on impulse and bought a load of kit. However in practice there are just too many hoops to jump through in areas that I simply do not have any expertise.
So I got myself a DJI F550 Hexa kit with Naza M v2 a couple of weeks ago, and had it built, configured and flying with pretty good tuning set-up in only 3 days, and I am having fun with it.
I just helped a buddy get a PixHawk running on a quad, and that was pretty straight forward.
Now rather than abandoning AQ6 is there anyone among the AQ6 experts who would be willing to do a full Calibration and core setup of one (or 2….) of my AQ6 boards with DIMU, and accept an AQ6 rev 0 board as payment? This way I can get flying (FCP-HL Quad) and with a good base configuration can move forward from there??
I must confess (having successfully built a 2 seat light aircraft that I have flown for nearly 950 hours, built electronic devices of many sorts when I was younger) that with the AQ6 I have “bitten off more than I can chew!”
From the postage/customs/TAX perspective It would be easier if it were someone from Europe, but if this assistance/service is possible from one of you kind experts else-where, then I will be very grateful.
Edmund