AutoQuad Forum

Hello,

My quad got flashed with AQ FW ver: 6.8 BETA rev260 b1496.(I didn't do the flashing)
Before my quad was not even arming after flash. I loaded the parameters on there and I configured the Magnetic position.
The quad arms with RC now but as soon as the quad arms, the GQC disconnects from the AQ and I am not able to reconnect. I am using GQC v1.6.1

I see the status of the quad go from standby to arm. I also hear the AQ board beep when it arms. Finally the motors are not doing anything when I push the throttle through the RC controller.

Thanks,
Ternovi

Hi Ternovi,

You should use the latest Beta7 firmware: http://autoquad.org/software-downloads/ ... oad-wizard

The old one obviously doesn´t fit the 1.6 GUI. Also please check your parameters afterwards, might not fit also since a lot has changed from Beta6.8 to Beta7.

Norbert

Hi,
Thank you for your directions Norbert.

I am a real noob when it comes to this, so I would appreciate it if you could guide me as to what I need to compare it against?

Do I generate new parameters or...?