Hello,
My quad got flashed with AQ FW ver: 6.8 BETA rev260 b1496.(I didn't do the flashing)
Before my quad was not even arming after flash. I loaded the parameters on there and I configured the Magnetic position.
The quad arms with RC now but as soon as the quad arms, the GQC disconnects from the AQ and I am not able to reconnect. I am using GQC v1.6.1
I see the status of the quad go from standby to arm. I also hear the AQ board beep when it arms. Finally the motors are not doing anything when I push the throttle through the RC controller.
Thanks,
Ternovi