Mag calib does not run - help needed

Info and discussion about the original AQ v6 flight controller

Re: Mag calib does not run - help needed

Postby Crizz » Thu Jan 22, 2015 10:44 pm

okay, maybe my firmware revision before was below the named version - and thats what confused me.

About SD-card : card is still installed, did the whole calibrations for IMU - and just when i gathered all data, DIMU was available , thats why i decided to upgrade. Its a class-10 and it worked fine in each environment on the calibrations duty, thats why i kept it into the slot. But really - i never heared about saving config params to SD before. Shame on me.

The PPM-chapter i already read before upgrading to DIMU, and i dont know why it didnt work with QGC 1.61 - i used 1.5r6 in the evening and got everything adjusted easily, w/o bouncing stick-values. Will check tomorrow with 1.61 if its still the same or done now, but it was simply strange, have no clue why 1.61 didnt run with the "ppm" setting tonite
Crizz
 
Posts: 211
Joined: Sat Aug 09, 2014 3:43 pm

Previous

Return to AutoQuad 6 Flight Controller

Who is online

Users browsing this forum: No registered users and 1 guest

cron