Tare works, but can not be stored

Info and discussion about the original AQ v6 flight controller

Tare works, but can not be stored

Postby fseider » Wed Oct 08, 2014 8:33 am

Hi,

if I make a reboot after save, the hud is wrong again.
Are there any solutions for this problem?
I used ther Firmware aqv7.0.r429.b1820-hwv6.1-dimu1.

Thanks in advance!

Regards Frank
fseider
 
Posts: 63
Joined: Thu Aug 07, 2014 8:28 am

Re: Tare works, but can not be stored

Postby JussiH » Wed Oct 08, 2014 8:13 pm

Tare is temporary.

To make it permanent you can either connect to gui, refresh all params and then write to flash or Eeprom

Or you can store to Eeprom using: Throttle stick left/down, Pitch stick up/right. All LEDS will go solid for a second to confirm.
JussiH
 
Posts: 2103
Joined: Thu Jun 21, 2012 9:25 pm

Re: Tare works, but can not be stored

Postby fseider » Wed Oct 08, 2014 8:46 pm

Hi,

a flashed a new Firmware and now it works.

Regards Frank
fseider
 
Posts: 63
Joined: Thu Aug 07, 2014 8:28 am


Return to AutoQuad 6 Flight Controller

Who is online

Users browsing this forum: No registered users and 26 guests