by afernan » Thu Jul 26, 2012 8:05 am
Radio Connection: FUTABA
To add in wiki something like:
"If using a FUTABA S-Bus receiver you must activate it in the firmware (default is Spectrum):
1.- Connect to AQ using QGC. Set "Main widget - Autoquad"
2.- "Flashing and Setup". In "Radio Type" set "FUTABA"
3.- Transmit to AQ > yes
4.- Reset AQ.
5.- Connect again to AQ.
Now the Radio should work. Blue bars moves with Tx sticks"
Additional comments:
- Bluebars showing Rx channels moves slowly (1-2 sec after moving the Tx stick) Is it normal?
- Channels are set for Throttle in the right stick (normally in Europe is used as Ch3 in left stick) How to change?
Angel