WIKI: improvement proposals from newbies experiences

[kinderkram]

Johan, the problem with the APC220 is the low airspeed of 19200.

You can see the hud and other values but if you try to reload the complete set of parameters fro the AQ again you might run into a timeout.
It works well for transmitting data from the FC to the GCS but not vice versa.
I'll update the wiki on that matter.

[LPR]

[Lyagukh]

[GoFaster]

Igor -

What air rate are you using? Did you also enable the error correction feature which halves the effective throughput?

Regards,
- Felix

[Lyagukh]

[GoFaster]

Same as mine except I am using 115200 serial speed. Figured 64K air rate (32Kb/s effective air rate with ECC enabled) should be enough for telemetry.

Sorry all, just realized I cluttered up the Wiki improvement thread. Please feel free to move.

- Felix

[teramax]

What i missed in the Wiki is that the white arrow marks the signal-pin.
Certain nothing bad happens when u plug in the wrong way but could be helpful.

MäX

[kinderkram]

Ummm: "The white arrow on the PWM outputs marks the signal pin for the ESC’s or PPM input."
http://autoquad.org/wiki/wiki/getting-s ... ller-setup

[LPR]

[Max]

On the status LEDs docs page (http://autoquad.org/wiki/wiki/getting-s ... atus-leds/) please add:

Debug -- Slow .5hz bright blink means a saved parameters file (PARAMS.TXT) is available on the inserted SD card.

reference thread: viewtopic.php?f=27&t=580

Also the colors don't match my board... but that's easy to figure out since they're labeled in the pic.

Thanks,
-Max