Is it possible to connect 4little digital servos to the AQ?

Info and discussion about the original AQ v6 flight controller

Is it possible to connect 4little digital servos to the AQ?

Postby TheBone » Thu Aug 21, 2014 1:19 pm

Hi,

I planning to use 4 smal servos. (This one: http://www.conrad.de/ce/de/product/2754 ... ggest=true)
That is a digital servo. I checked the voltage and the amps and I got ~5V with a max amp of 75mA (specs said 100mA is max.).
Could I connect four of that to one port of the AQ board? And if not, what solution would you prefer to solve this problem?
Your Wiki said that it is not recommended to use digital servos, e.g. for gimbals, but is it possible? (http://autoquad.org/wiki/wiki/autoquad- ... s/?lang=de) And if it is, how can i control the servos? On an onther site, you write, that it isn't possible. (http://autoquad.org/wiki/wiki/getting-s ... ler-setup/) I'm confused. ^^

Thanks in advance.
TheBone
TheBone
 
Posts: 50
Joined: Tue Apr 29, 2014 2:50 pm

Re: Is it possible to connect 4little digital servos to the

Postby bluuu » Thu Aug 21, 2014 1:28 pm

you can use it but recomended is to power them by external U/SBEC
bluuu
 
Posts: 1339
Joined: Mon Oct 29, 2012 8:02 pm
Location: Poland, Silesia


Return to AutoQuad 6 Flight Controller

Who is online

Users browsing this forum: No registered users and 12 guests

cron