by Jean » Mon Jul 28, 2014 11:36 am
Hi kinderkram and joebar.rc,
I know what you said about manual mode and normal flight, I just make a mistake taking the screenshot.
I switch to a acrobatic mode with the futaba, and with the QGC I can see the blues bars moved in the rioght way, without any aother connection, pitch moved alone and well, roll too ... so that the first good point.
After that, I did an other other other time the esc calibration with my grandson, but it's still the same problem, motor 1 begin first, after 2&4 and at last the 6. I connect all the esc to the channel 3 of my RX, I power the TX, reverse the throttle, max the throttle, power the esc& rx, heard the beeps without any motor running, throttle to min, heard the beeps without any motor running. And when i reserve in the right way the throttle and reconnect the esc to the AQ board, nopthing change, they are still dislinked..
In the futaba, the channel seems to be: 1AIL 2 ELE 3 THR 4 RUD
and in the QGC the channel 1: THROTTLE 2 ROLL 3 PITCH 4 YAW
for me it's strange, I thought that I had to put the same channel, so change the channel on QGC, but when I put to the AQ channel 1: ROLL 2 PITCH 3 THRO 4 YAW, I can see that when I move the sticks they don't move where I want, they are switched. I use the S-BUS and I have an inverter...
I don't see what I can do next..
Thanks a lot for helping me.
Best regards
Jean