Hi,
I am new here and this is my first project with the AQ. I am having a problem with my GPS where it reports an accurate lat/lon but a bad alt that jumps around and refuses to settle. A couple weeks ago I was able to get 3D lock no problem - indoors even - but now it never locks. The antenna is connected. I have let it sit for hours and the GPS never locks. I have attached a log of gpsData.height that shows the crazy altitude readings.
I did have one event; I was testing my system with some new ESCs and when I connected the battery (3S) there was a spark and an obvious near short - it ended up being a bad ESC from the factory (I neglected to test them individually before installing - my bad). When this happened I the AQ was connected but powered with a different battery and until now it did not show that it had been effected in any way.
As far as I can tell the AQ works perfectly in all other respects; it communicates fine, accepts receiver information from S-Bus with no issues, reads/writes the SD card, reports accurate attitude information, etc..
I`m wondering if the u-blox lost a config or something - is that possibleÉ
Thanks,
Steven