I use the T-Motors Navigator Series MN 3508-16 with 700 k/V, Joerg.
Today i did several tries connecting ESC32 and AQ - after i reinstalled the Silabs CP210x VCP. Had driver version 6.6 installed (Feb.14), uninstalled driver and installed new 6.7 - no changes. Except that i even can´t access the AQ even now
When i selected "connect", ist stays unconnected. Wehn i choose "read current..:" it says it has read, but shows none - and even stays unconnected.
Tryed with Silabs UART with 4-pole wire, with 6 pole, nothing. Checked that baudrate was set to 230 k, 8n1. Doesnt even matter if i choose flowcontrol or not. This is becomming very strange now. Even if i repower the AQ, no connection. Normally with 1.3 the AQ reconnected automatically to QGC with voice-out ( is set to active ), but actually it stays disconnected.
Guess i should verify that Flyduino FTDI and my FTDI are still okay, to avoid that bad serial adaptor causes the problems....