Hi,
my AQ has already 117 flights without any issue or big crash, and today suddenly it flipped in about 20 meters above ground, most probably due to wind gust.
Nothing broken apart from some nylon screws, among them the one holding the AQ to the frame.
When powering the AQ, nothing happens, no LED, everything remains dark.
Attached the log of the last flight with the crash.
I have no idea what is wrong with the AQ, and even more no idea how to get this corrected.
It is very sad, as this was the final test and setup flight for the gimbal before going into holiday where I had planned to take a lot of videos.
Looking at the AQ, I cannot see anything which looks broken or any loose soldering.
Here the log of the HoTT telemetry:
Motors init
Control init
Control task started
Gimbal init
Gimbal PITCH stabilization port initialized.
Radio task started
GPS task task started
Gimbal ROLL stabilization port initialized.
Gimbal TILT control port initialized.
HoTT Telemetry init
AQ S/N: 36373532-33314719-00220025
Mavlink SYS ID: 11
SYS Clock: 168 MHz
8274/8274 heap used/high water
30536 of 38912 CCM heap used
Run task started
HoTT Telemetry task started
AQ FW ver: 7.0 - EXPR rev38912 b1673, HW ver: 6 rev1
Disarmed
Initialization complete, READY.
Armed
GPS: trying new baud rate
RTC set: 2014-05-15 12:37:33 UTC
Altitude Hold engaged
Home position set
Position Hold engaged
Home position set
So there is nothing looking strange.
I wanted to attached the log, but it is too big even zipped it is more than 7MB which is above the limit here.
I would be very thankfull if I could get any help to get it flying again.