Hello,
While I was trying to find out the origen of the MAG problem in my calibration (viewtopic.php?f=27&t=3027), suddenly the communications to the AQ board were not working. I'm trying to connect me via USB UART, 3DR radio and bluetooth communication but nothing. The situation was: I did a reset factory via USB UART, setting CONFIG_VERSION parameter to 0 (Onboard Parameters>config). It was succesful.
This process cleans all the configuration parammeters, even the motor mixing setup. The problems came when I connected to the board via 3DR radio to upload the mix file. The process was succesfull but after that I couldn't connect to the board again.
The AQ board seems to work ok, leds ok, logs ok...
I can't reload the firmware.
Please, I need help ...
Thank you in advance.