Hi all,
Just got my AQ board and having exchanged the RECOMs (for higher voltage versions) and attached the header pins, I put it in the freezer for an hour, then let it warm up over 90 minutes. Red LED was solid, Green LED was flashing every time I checked it. Resulting log file? 0kB
I've just formatted the card and tried 5 minutes of logging ... resulting log file was about 3.1MB ... should have been at least 20MB from the average '4MB/min' statistic I've read in the Wiki. Should the default logging rate produce this approximate data rate?
Any ideas what to look for? I've bent that little pin down in the micro SD card slot, but other than that I don't know what to try next ... Didn't think I would be having problems this early on!
Many thanks for your help,
David
PS. Using a Samsung 8GB Class 10 Micro SD card.