AutoQuad Forum

Posted: **Fri Nov 22, 2013 3:37 pm**

Hello,

Recently I have changed the firmware aqv6.6.0-rev2 to aqv6.7.r224.b1400-rev0 because i thought that I had a R1 board. Finally I have a R0 board. With the firmware aqv6.6.0-rev2 my Spektrum DX18 worked well, but now with the new firmware the radio values don't change when I move the sticks. It seems the firmware could have a bug. I have loaded the old firmware and everything is going all right. Is there anybody with the same problem?

Thanks in advance

Manuel

Posted: **Fri Nov 22, 2013 5:40 pm**

Hi Manuel,

the naming of the board revisions has changed some time ago.
Now r1=r0 and r2=r1
So you should use r1 for your board (formerly r2). Also make sure to use the latest QGC to match features & settings.
It´s currently 1.3 RC 2.1: http://autoquad.org/software-downloads/?did=73

Posted: **Fri Nov 22, 2013 11:40 pm**

Thank you very much kinderkram. With the new QGC it works again.
I have another question about the maximun and minimun radio values. QGC shows:
Throttle Min 4 Max 1368 (approx 0/+1400)
Roll Min -681 Max 681 (approx -700/+700)
Pitch Min -681 Max 681 (approx -700/+700)
Yaw Min -681 Max 681 (approx -700/+700)
What can I do for improve this values? is it necessary adjust them to the recommended range?

Posted: **Sat Nov 23, 2013 1:20 am**

you can change end points on your TX but those values are acurate to flight

AutoQuad Forum

Spektrum Radio don't work with aqv6.7.r224.b1400-rev0

Spektrum Radio don't work with aqv6.7.r224.b1400-rev0

Re: Spektrum Radio don't work with aqv6.7.r224.b1400-rev0

Re: Spektrum Radio don't work with aqv6.7.r224.b1400-rev0

Re: Spektrum Radio don't work with aqv6.7.r224.b1400-rev0