I can´t make my radio work with AQ

Info and discussion about the original AQ v6 flight controller

I can´t make my radio work with AQ

Postby leandrolb » Sat Oct 26, 2013 3:35 am

Hi there,
Any help is welcome.
I have a Turnigy with FRsky module using PPM signal to comunicate with the board under channel 14. I changed the radio setting at the Ground Station reset the board many times and the radio continue not working.
This is my second AQ, the firt one fried. But withe the first one I could get the radio work successfully.
May I am missig some detail that I dn´t realize yet.
Leandro Barancelli - Brazil
Hexacopter - AQ - frame Tarot 810 - 15x5 carbon fiber props - motors Tarot 4114 - 6S 10000mah
leandrolb
 
Posts: 32
Joined: Thu Jul 11, 2013 7:46 pm

Re: I can´t make my radio work with AQ

Postby leopold1 » Sat Oct 26, 2013 11:03 am

Can you take a photo of your redaio setup connected to the aq board?
I have the same hw and it flies fine.
leopold1
 
Posts: 311
Joined: Tue Jul 31, 2012 11:43 pm
Location: Belgium

Re: I can´t make my radio work with AQ

Postby leandrolb » Sat Oct 26, 2013 7:32 pm

Yes! it worked!
A really great friend of mine has been in my home to catch a pulverazer to use in his home.
I coment to him about the problem I have been experience with AQ and he take a look into the board and figure out that the signal PIN of 14 port have a poor solder. I doubt that was the problem. But it was the problem. I did the solder again and it worked! And he helped me with the radio config as well.
Now I am ready to move on to the Calibso dance.

Let's do this!
Leandro Barancelli - Brazil
Hexacopter - AQ - frame Tarot 810 - 15x5 carbon fiber props - motors Tarot 4114 - 6S 10000mah
leandrolb
 
Posts: 32
Joined: Thu Jul 11, 2013 7:46 pm


Return to AutoQuad 6 Flight Controller

Who is online

Users browsing this forum: No registered users and 20 guests

cron