Hi ,
first im new here in AQ .
My Name is Jean - Paul im 40 Years old ,from Germany ( Near Heidelberg )
I got a used AQ6 Rev 1 Board (With all the Static Calibratios ) and wanted to Install this on my Hexa.
All worked fine so far the Motors running etc , the HUD was leveled . So i want to make a little test flight .
The Flight was not succesfull , two Props are broken . In Case of some Strange reactions to the Radio Input.
So i was searching for the Problem.
In the GCS i thougt i found it , because i use Futaba and my Channels should be
1 Roll
2 Nick (Pitch)
3 Throttle
4 Yaw
If i do this Setup in the GCS there is no way to get the Radio Inputs right .
The only way to get the Radio Inputs right was to leave them at
1 Throttle
2 Roll
3 Pitch
4 Yaw
So i thougt it could be the S-Bus converter who do this failure , an so i powerd the AQ and check my wireing , than it happens i think i do a short on the Board ( dont ask me how , i did not Notice it ) an all of the LED´s stays dark
I wrote a Message to Jussi if he can take a look on the Board to fix it , otherwise i have to buy a new one.
Sorry for my Bad English , i hope it gets better the more i Read and write here.
Greets
Jean