AQ6 Rev1 RIP

Info and discussion about the original AQ v6 flight controller

AQ6 Rev1 RIP

Postby d3frost » Sun Oct 06, 2013 12:22 pm

Hi ,

first im new here in AQ .
My Name is Jean - Paul im 40 Years old ,from Germany ( Near Heidelberg )
I got a used AQ6 Rev 1 Board (With all the Static Calibratios ) and wanted to Install this on my Hexa.
All worked fine so far the Motors running etc , the HUD was leveled . So i want to make a little test flight .

The Flight was not succesfull , two Props are broken . In Case of some Strange reactions to the Radio Input.

So i was searching for the Problem.
In the GCS i thougt i found it , because i use Futaba and my Channels should be

1 Roll
2 Nick (Pitch)
3 Throttle
4 Yaw

If i do this Setup in the GCS there is no way to get the Radio Inputs right .

The only way to get the Radio Inputs right was to leave them at

1 Throttle
2 Roll
3 Pitch
4 Yaw


So i thougt it could be the S-Bus converter who do this failure , an so i powerd the AQ and check my wireing , than it happens i think i do a short on the Board ( dont ask me how , i did not Notice it ) an all of the LED´s stays dark :-(

I wrote a Message to Jussi if he can take a look on the Board to fix it , otherwise i have to buy a new one.

Sorry for my Bad English , i hope it gets better the more i Read and write here.

Greets

Jean
d3frost
 
Posts: 9
Joined: Sun Oct 06, 2013 8:48 am

Re: AQ6 Rev1 RIP

Postby Jdmagoo » Sun Oct 06, 2013 10:49 pm

In your radio you can change from stick mode 1 to stick mode 2 etc etc. This will swap them around. Always good to hold onto the multirotor on the ground and check your radio sticks before first take off. You may need to make further adjustments.
Jdmagoo
 
Posts: 485
Joined: Sun Feb 17, 2013 8:35 am

Re: AQ6 Rev1 RIP

Postby bluuu » Sun Oct 06, 2013 11:26 pm

you can set channels to functions in QGC
bluuu
 
Posts: 1339
Joined: Mon Oct 29, 2012 8:02 pm
Location: Poland, Silesia

Re: AQ6 Rev1 RIP

Postby d3frost » Mon Oct 07, 2013 6:05 am

Hi,

i tryed to change them but it takes not the effect that i expected . When i change the Radio Inputs in the QGC the QGC shows me the rigth channel but the wrong inputs .

I Hope with a new Board the Failure is gone.
d3frost
 
Posts: 9
Joined: Sun Oct 06, 2013 8:48 am

Re: AQ6 Rev1 RIP

Postby sandmen » Mon Oct 07, 2013 7:12 am

Did you always save your changes to the ROM and do a restart?
sandmen
 
Posts: 997
Joined: Fri Jun 22, 2012 7:25 am

Re: AQ6 Rev1 RIP

Postby d3frost » Mon Oct 07, 2013 7:15 pm

Yes, like you told me on the Fpvc already.
d3frost
 
Posts: 9
Joined: Sun Oct 06, 2013 8:48 am


Return to AutoQuad 6 Flight Controller

Who is online

Users browsing this forum: No registered users and 13 guests

cron